XDIMAX Products Forum

Hi
I have just finished testing and the good news is that it is now working. Thanks again for all your help. I'm very grateful to an excellent support.

Best Regards

Hi
I had a quick look at the waveform and it looks ok. I will apply this signal to the system and will let you know.

Many Thanks

Rest of the waveform is ok.

Thanks

Hi
I tried it and it is still not working. The SCS line should remain high once the four bytes are transfered but there is a low pulse which i think is creating problems. I tried all the possible configurations but this (low pulse) remains there. I have attached the waveform.

Thanks again

Thanks. I will let you know

Hi
This is correct. Thanks for the explaination about sending more bytes

Hi Here are the details SCK (Clock) 8 cycles [Frequency 250KHZ, High time 2.2uS, Low time 1.8uS] (Total time for 8 cycles will be 32uS) Clock idle time 23uS (Clock remains low during this time) The above pattern will transfer 1 byte and this pattern needs to be generated 3 more times in order to tra...

Here the actual waveform with details. The clock frequency (SCK) is 250KHZ and not 25KHZ

Hi Sorry for a very late reply. I was busy and in some other projects. I recently tested the firmware but unfortunately it is not working. I think the problem may be with the width of the SCS high pulse. The pulse width is about 1uS (current driver) and the actual pulse width required is 2.8uS. The ...

Hi, I have prepared custom FW for you. It make unconditional (regardless SS Config) SS high pulse. Please check it and let us know. Hi Thanks for preparing this custom firmware. I had a quick look at the waveform and I think it should work. I will do some testing and will let you know. Thanks again...